AfterDawn | News | Guides | Software downloads | Tech Support | Forums
AfterDawn: Tech support
  0   0

How to properly connect the wires red, blue and green between TV and DVD. Do I need anther wire?

Asked by: Anonymous User, 07 May 2011 0:29


  1   0
20TONS (215)

From the component in to your TV to component out on your DVD player. This is for the video signal only. You will also need the red and white composite cable as well. These will also go from audio in on your TV to audio out on the DVD player.

09 May 2011 1:56
  0   0
xboxdvl2 (425)

you shouldnt need another wire.1 wire should go from video out on dvd player to av input video on tv the other 2 do the same but for audio.we use yellow,white,red here in australia usually but same thing different colours.the main thing is red goes to red on both tv and dvd player,blue goes to blue,green goes to green.

07 May 2011 1:15
  1   2
Unverified new user

WIRES:wires are colorblind i.e.,wires do not know what color they are,and do not forget this ! _ever.

08 May 2011 12:00
  0   2
Unverified new user

RGB are analog cables.
If you have HDMI connector on your setup use that.
RGB will be no longer be available I think in 2012.
MPAA calls RGB the analog hole (paraphrased).

07 May 2011 8:53

Suggest a better answer

If you do not have an accout yet, please enter a nickname and your email address below.

We will send an account activation link to the email address you provide, so please make sure to use a valid address. Content will be published on site after you have activated your account.

If you already have an account, please login using the next tab.

Login by using your AfterDawn username or your email address.


Before you can ask a question you need to login.

Login / register

Top users during the past 7 days

How the Top User chart works?